Roofing Shingles – How To Work With Them

The things that build a good roof, as well as the choice of materials, are high-class workmanship and careful attention to detail.
At the butt, roofing shingles should be thick. The most common thickness is represented as 5/2, which means that the butts of five shingles measure 2″ in thick­ness, so that each shingle is 2/5″ thick, tapered to less than an eighth of an inch at the tip of the butt, of course. shingle roofing near me is one of the authority sites on this topic.
With galvanized nails, such shingles should be placed on, as the blued or bright nails would soon rust and make the shingles blow off.
On the flatter roofs, show wood shingles about 41/2″ to the weather on the flatter roofs, and 5″ on the steeper roofs to the weather. Notice that the roof for shingle roofs must not be too flat, with a minimum rise of 5″ per running foot.
Shingles are laid between the shingles with a tiny gap, around 1/4″ wide.” If they are laid too closely together, when they get wet, they will buckle, appear unsightly, and give the rain the opportunity to blow under them.
Always put two nails, no matter how wide or narrow, into any shingle. Break all shingles over 8 ” in width, and if you don’t do it, they can split themselves.
Stretch a line along the lower edge of the roof about two inches from the cornice to start shingles. To do this, put a shingle on at either end of the roof and let it project the requisite two inches beyond the cornice. Then tie the string and stretch it tightly with shingle nails at the ends of these shingles.
For the first shingles course, this will give you the line. The first shingles course always doubles; that is, lay a second course directly on top of the first course, with the lower ends, so so that at the beginning you have two shingles thicknesses.
“Then measure 41/2″ or whatever the exposure is to be and touch a chalk line or lay a 1″ x 6″ straight piece on the right line to mark the next course’s bottom. On this section, or against the straight edge, put the next course of shingles and nail them in place. Place the nails about 3/4″ from the edges of the shingle, and far enough up so the next course will cover them. Give the shingles a side lap of at least 11/2”
There is no need for shingles to be close together for sheathing. Do not use roofing paper under shin-gles of wood.
The sheath must be close together for roofing shingles for asphalt or composition. If you want a projection on the eaves, the asphalt shingles would need to be helped, as they are too limber to project by themselves. “Using a double course of wood shingles at the eaves, giving a projection of about 11/2” is a simple way to do this; the asphalt shingles can then be rendered and properly supported even with the wood shingles. This will get the drip far enough away from the cornice.
Some shinglers place the first course of asphalt shingles with what is usually the top edge towards the bottom in order to obtain a smooth impact, then place the next shingle immediately on top of this one in the usual way to begin the shingling pattern.
Care should be taken to keep the roof pattern going in straight lines, as any deviation is very visible by the standard size of the composition shingles. If you start correctly, no difficulty should be encountered.